No matter how good the fiber fusion splicer is, there will be losses after fusing the fiber, which represents the quality of fusion. If the losses are too large, they will directly affect the overall circuit. The following measures can be taken:
1. Check if the cutting blade is jerky, replace the blade or cutting angle
2. Check if the V-groove of the fusion splicer is clean and if the presser foot is flexible
3. Is the electrode aging caused by prolonged use
4. Is the electrode fixed or offset
5. Check if the fiber optic is placed correctly
6. Check if the main board of the fusion splicer program is functioning properly. Problems with the high-pressure pump can cause abnormal discharge
7. Has the machine ever been dropped? If the controller motor is misaligned after the fall, it can cause excessive wear and tear
8. Is the fiber optic fusion splicer regularly maintained and should be kept clean and discharge clean